opnsense igb2 not offered as interface
Hi,
i have a problem installing zenarmor on one of our opnsense devices and i hope that someone here can help me.
We are using ax0 as lan interface and igb0, igb1 and igb2 as wan interfaces. igb3 is our sync interface for ha.
When i go to the selection page all interfaces execpt igb2 are shown and can be selected.
Can anyone tell me what i am doing wrong?
-
Official comment
Hi Cornelius,
Thanks for reaching out to us and letting us know your issue.
On BSD-based systems, such as OPNsense and pfSense, the WAN interface or default gateway interface of the firewall is not displayed by default on the Zenarmor configuration page, so you cannot choose to secure them.
You may find more information at: https://www.zenarmor.com/docs/troubleshooting/configuration#wan-interface-not-detected
Best Regards.
Comment actions -
Okay, understood.
It is only confusing as i did configure another opnsense yesterday and did not notice, that only one wan was selectable instead of two.
So if i get it right you suggest that wan interfaces should not be protected by zenarmor, so i will only sleect internal interfaces, right?
Please sign in to leave a comment.
Comments
4 comments